Glue Pot Edge Bander
for staight and curved panels
110 Volts
Model: PEB150-TRC
Made in Germany under Virutex label.
Assembled in Spain at Virutex factory
Glue Pot Edge Bander for :
- Small shops
- Large factories who do custom/curved work
Glue pot bander with temperature control
For PVC, Polyester, Melamine, wood veneer
tapes of up to 3 mm and plastic laminate strips.
( When using 3 mm tape for curved panels, we recommend
using soft 3 mm tape. Hard 3 mm tape retains its memory &
tends to get back to straight form after banded on curved panels.
Use of hard 3mm tape for curved panels requires heating the tape
too to soften it. Our machine and most of the glue pot banders do
not heat the tape & only heat the glue & apply to back of the tape
If you can not find soft 3m m tape for curve panels we recommend
use of 2mm tape for curved panels)
- Easy and fast set up of tape height and panel thickness
- Automatic tape feed with control
- Fast heat up time of 10 minutes
Ideal for small shops or Large factories who
need a machine for custom works, such as
curved panels or large counter tops.
Open the fence to the width
of the panel.
Easy to edgebanding Curved Panels
Remove the unit from the table
and use it as a portable bander.
Perfect for banding very large
panels or countertops
For Full details of accessories available for this machine
and the portable one, please check the web page for
PEB50, the portable model
Glue pot hot melt edgebander with stationary table.
For banding PVC, ABS, melamine, laminate and veneer tapes
previously cut to the desired length, on shaped, curved or straight panels.
Very practical for small straight panels banding series in the workshop
and very easy to handle.
Easy and fast setting up of the tape height and panel thickness.
Automatic feed of the tape with manual control and motorized pressure
roller for a precise and fast banding.
The quantity of glue to be applied on the tape can be adjusted.
Can be used as portable just removing three screws
|
|
|
| Specifications:
|
|
|
| Max. tape thickness:
|
0.5- 3 mm ( 1/64" to 1/8" )
|
| Minimum Concave radius to band: 1.57" ( 40 mm)
|
| Input power:
|
765 W - 110 Volts, 20 Amps, single Phase
|
|
|
| Tape width:
|
12-45 mm ( up to 1.77")
|
|
|
| Tape feed speed:
|
3,6 m/min or 10 Ft./minute
|
|
|
| Tank capacity:
|
150 cm3
|
|
Glue usage of a tank (average):
25 meter of 23 mm wide tape
or 75 feet of 1" wide tape
|
| Work temperature:
|
170 to 190 C°- Adjustable Temperature
|
| 260 to 390 F.
|
| Weight:
|
24,7 Kg - 70Pounds ( 90 Pounds Gross weight of the wooden crate)
( the crate is shipped by common carrier)
|
| Weight of the hand held unit is : 18 Pounds
|
To down Load catalog, click on:
|
|
|
|
Included with this machine:
One unit of AU93 - Double edge trimmer for up to 1 mm tape
One unit of RC21E - End Trimmer for up to 1 mm thick tape
One unit of ET6 - Single side edge trimmer for up to 1 mm tape (recommended for veneer tapes)
one unit of ET7 - Single side edge trimmer for curved panels
|
|
|
|