$7,400 reduced to $6,900 - shipped freight collect
Most popular automatic bander for small shop since 1975.
Call 1-800-868-9663 x3 to ask for user references in your area
Watch our video on web or ask for a FREE video
Easy to adjust. Easy to change parts
For panel edge banding with pre-glued PVC, Melamine and wood veneer tapes.
Automatic power feeder with speed of 15 Ft. per minute.Motorized top and
bottom flush trimming unit. Automatic front and back flush edge trimming.
No compressed air or dust collector required.
Specifications:
- Speed of 15 Ft. Per minute.
- Advanced power feeder with:
- Brushless motor
- Multi Layered Belt backed with hard rubber wheels for a
better gripp and stable movement important when banding large boards
- Board thickness range from 7/16" up to 2" thick
- Maximum tape thickness: up to 1 mm
- Electronic temperature control with range of : 0 - 900 F ( 0 - 500 C)
- 220 Volts, Single, 20 Amps, 1,000 W.
- Welded steel structure with great stability
- Net weight: 260 Pound
- Dimensions: 67" x 37" x 53"
Fully automatic power feeder with speed of 15 ft. per minute.
Multi layer belt backed up with wheels for stonger and consistant grip
Electronic control panel for heat control, feeder, and emergency switch
Top & Bottom auto flush trim. Spring loaded bearing guides automaticall readjust the cutters
to take into account the variation in thickness of the board and always give give flush cut.
Auto front and back flush cut by a paid of blades activated by a stong magnet.
Spring loaded assembly makes sure the front cut is always flush. The back cut
is adjustable in order to take into account any stretch factor caused by plastic tapes
Please click on links below for:
Parts Replacement Videos
Top & Bottom Trim Station
Trim Station Blades Adjustment
Trim Station Blades Holder
Trim Station Motor
Front Blades and magnet
Power Feeder & Belt
Control Panel Switchs
Tape in feed track and center plate
Heater
Remove Center deck to get to heater or back blades
Back Cut Blade Magnet
Back Blade Magnet
Back Cut Blade
Temperature Control
Putting the deck back
If you have bought an old used EB25
and has not been kept well you may need
to make some adjustments.
For Front cut blade adjustment, Please click on:
The sensor that tells the blade to close at the right time
might be out of adjustment
For Trim Station Bearing Adjustments click on:
If the top and bottom of the board do not cut flush
the bearings might need adjustment
This video is being repaired